Mitasu flush fluid

Question: In what cases the purging should be used?

Mitasu Oil Expert Help: On any change of used oil type (to a new brand or to a new oil type of the same brand), it is desirable to use the flush fluid.

– Also the flush fluid should be used if you have any doubts in the quality of the engine oil already used (the engine makes noise, it is difficult to start or you have doubts because of the possible forgery of the acquired oil, for example, in a plastic canister).

– Use of flush oil is recommended in the case of engine oil darkening in the engine or during prolonged operation of engine oil, exceeding the recommended term.

– In case if you had to pour motor oil, without being sure that you refill absolutely the same motor oil, as the one already used in the engine.

– After repairing the engine in the service centers (experts will offer an additional rinse of the engine if necessary)

– It is particularly important to completely replace the engine oil after the purchase of a second-hand vehicle; it can be done only by using high-quality effective, but gentle flush fluid for the engine.

Question: Should one use a special flushed additive into the old oil? Why is the flush fluid better than the microadditives into the engine?

Mitasu Oil Expert Help: We do not recommend using any additives in the engine because of the possibility of uncontrolled chemical reactions in your engine. It is optimal to use the products of the same company, which formulas are developed or tested by many special tests and experiments, and suit each other. Particularly the Mitasu Flush Fluid has been tested with all products of Mitasu Oil Corporation, Japan, and can prepare the engine for the transition to a new type of oil most efficiently.

Question: How long is it necessary to flush the engine?

Mitasu Oil Expert Help: The technology of using Mitasu Flush Fluid is simple:

1. Warm up the engine to operating temperature

2. Drain the old oil completely

3. Pour the same amount of Mitasu Flush Fluid into the crankcase

4. Start the engine and let it idle for 15 minutes

5. Drain the spent Mitasu Flush Fluid completely

6. Replace the oil filter

7. Pour the new Mitasu Engine Oil in the engine

If the old engine oil is considerably contaminated, we recommend replacing of oil filters twice (the first time before pouring the flush fluid and finally - at the sink of it).

Question: There is an opinion that the purging procedure is too rough and it only harms.

Mitasu Oil Expert Help: Indeed, there is such an opinion. It is important to separate different aggressive "purging" in the form of 5-minutes which can peel off all the deposits, but not remove them from the engine and thereby significantly damage the engine from balanced formulas of flush fluids that gently but effectively clean the engine, not flushing out the useful deposits in the engine.

Mitasu Flush Fluid gently but effectively cleans the engine from any kinds of both suspended and deposited contaminants, leaving no unwanted delaminations in the engine. It is actually high-quality motor oil with low viscosity index and the optimal amount of effective cleaning additives. Thus, the flush fluid delicately prepares the engine to change of any type of motor oil, either mineral or synthetic.

Using one type of Mitasu motor oil for a long time we do not recommend the use of flush fluid, as all Mitasu motor oils have excellent cleaning performance due to the constituent quality base oil and detergent package-dispersant additives. But if you plan to switch from mineral to 100% synthetic motor oil we still recommend using the flush fluid.